KISS 30A اسپید کنترل

Its features are:

• 30A continuous, 45A burst (for short periodes).
• Oneshot 125 and standard (50-500Hz)PWM autodetect
• Very light weight (5,4gr.)
• Fine speed control (about 950 steps)
• No external cap (electrolytic capacitor) required
• Rapid implementation of gas changes
• Linear throttle response
• Active freewheeling (little diodes losses -> higher efficiency)
• Regenerative braking -> rapid throttle response at deceleration
• Fast FET switching by using real gate drivers
• Minimal dead times by an adaptive dead time
• 2 – 6S LiPo capable*
• Automatic detection of the One Shot Signal
• Second Signal Input for Fallback System
• PWM signal amplifier
• unique Over-voltage protection
• overcurrent protection at ~45A that just reduces the current.
• multicopter 3D (reversible) mode

* for 6S use:
Its strongly recommended to use a 220µF – 470µF 35-63V lowESR electrolytic capacitor on the lipo power pads when using 6S.

Using a fully loaded 6S lipo (25,2V) the ESC might need some seconds (10-30sec) in cold conditions before it will be ready (it will not start the motor or beep before). Once it is ready it will be fully functional!